Even if it’s a consolidated table… just asked for a library to facilitate sharing. K40 upgrade for Lightburn : r/lasercutting by Dzambor K40 upgrade for Lightburn Im trying to find board replacement for my K40 so I could use Lightburn. Yes there are many types of setups, but definitely a lot of commonality. I also have a LightObject upgraded lens as do many others. I suspect your machine ( +James Rivera) is a little different due to the lens setup. Basically, what you want seems more like information about how to use it than anything software can just “do for you”. Laser Controller Boards (4) Laser Accessories (2). ![]() Stuff like alignment or cutting settings are also available here, but are really more related to each machine as they are often different. Lightburn Compatible LX2b Laser Controller 2 axis A4988 K40 Upgrade. ![]() That information is available in this group though (i.e. K40 LIGHTBURN COMPATIBLE: This upgraded K40 motherboard makes LightBurn work with your K40 laser engraver. +Timothy Rothman I don’t think such a thing exists. K40 Laser Modifications dorcu (David) April 5, 2022, 4:28pm 1 Hello, I have removed the original electronics of my K40 laser and I have put a MKS DLC 2.1 controller board, I have followed several schemes that I have seen on the internet and I have connected it in the following way: 658×578 62.7 KB 668×615 51. I know there is a range of settings and each machine varies, but we should have a baseline that we can refer to in order to assess whether we need to clean mirrors, perform alignment or change the tube. Basic settings aligned to what a typical K40 would do. What are you expecting from a LightBurn “library”? Lightburn Compatible K40 Laser Controller Board Monportlaser Home Lightburn Compatible GRBL Motherboard for Desktop 40w CO2 Laser Engraver Click to expand Lightburn Compatible GRBL Motherboard for Desktop 40w CO2 Laser Engraver (2) by Monportlaser Save 55.00 99.99 44. ![]() It probably makes sense to upgrade it with a grbl or similar controller. Lightburn don’t recommend it as the K40 control board has no laser power control commands. It would be great to have some starting point. Anyone have a Lightburn library for the K40.
0 Comments
Leave a Reply. |